Underground Cable Fault Detection Methods

Two of the popular techniques are the murray and varley loop tests for locating faults in underground cables this article explains about few other popular techniques for locating faults in underground cables viz.

Underground cable fault detection methods.

But finding the exact location of the cable fault needs special techniques. This project uses the simple concept of. This paper proposes fault location model for underground power cable using microcontroller. The conventionally used aid in cable fault testing and location is the cable test van.

This project uses the ohms law concept when a low voltage dc is applied to the feeder end through a series resistor then the current would differ based on the location of fault occurred in the cable in case is there any short circuit occurred from line to ground then the voltage across series resistor alters accordingly then it is fed to an. If the fault is considered to be high resistive or intermittent a dc voltage can be applied to the cable to determine at which voltage the fault breaks down. Underground cable fault distance locator circuit. In order to identify the faults in the cable we need to develop special methods which will be discussed in this article.

There are many locating methods coupled with new detection technologies that make this task much easier and less time consuming. The van is installed with conventional cable measuring systems for quickly reaching the location of any cable fault. The challenge with the existing methods used for locating faults in underground cables is the inaccuracy in calculating the distance where the fault is located and the low durability of such. Syscompact 4000 cable fault location system with integrated tdr and thumper surge generator titron cable test van breakdown detection.

Fault points online method for underground cable are less than overhead lines. Finding the type of a fault in underground cables using a megger should not be a difficult task. The aim of this project is to determine the distance of underground cable fault from base station in kilometers. Before we discuss fault detection methods we shall study the various types of faults occurring in underground cables and their causes.

In 20 years that followed over 2000 fault location vehicles were manufactured more than half of which were intended for the former ussr.